Zeitpunkt Nutzer Delta Tröts TNR Titel Version maxTL Do 25.07.2024 00:01:05 37.302 +5 3.594.257 96,4 Mastodon.ART 4.2.10 500 Mi 24.07.2024 00:01:06 37.297 +8 3.591.703 96,3 Mastodon.ART 4.2.10 500 Di 23.07.2024 00:00:36 37.289 +4 3.589.133 96,3 Mastodon.ART 4.2.10 500 Mo 22.07.2024 00:01:10 37.285 +9 3.586.572 96,2 Mastodon.ART 4.2.10 500 So 21.07.2024 00:01:07 37.276 +1 3.584.128 96,2 Mastodon.ART 4.2.10 500 Sa 20.07.2024 00:01:11 37.275 +5 3.581.812 96,1 Mastodon.ART 4.2.10 500 Fr 19.07.2024 13:59:22 37.270 +5 3.580.286 96,1 Mastodon.ART 4.2.10 500 Do 18.07.2024 00:01:08 37.265 +7 3.576.970 96,0 Mastodon.ART 4.2.10 500 Mi 17.07.2024 00:01:10 37.258 +3 3.575.025 96,0 Mastodon.ART 4.2.10 500 Di 16.07.2024 00:01:08 37.255 0 3.573.732 95,9 Mastodon.ART 4.2.10 500
Shae M Puckett 🤖🖼 (@smerp) · 11/2017 · Tröts: 4.594 · Folger: 2.443
Do 25.07.2024 18:20
Make sure the power switch on the controller is off. Plug in the USB cable to the controller and the computer.
Verify your software can talk to the controller (we tested this before, remember?)
Plug the motor power supply into the wall and into the controller box. Do not plug in any motor cables at this time.
Adjust settings in your software so that you can manually control the plotter to move very slowly (10mm/s) and just a short distance (10mm).
controller box with usb cable and motor power attached
settings in Lightburn's manual movement tab, 10mm distance, 10mm/s speed
[Öffentlich] Antw.: 0 Wtrl.: 0 Fav.: 0 · via Web