Zeitpunkt Nutzer Delta Tröts TNR Titel Version maxTL Mi 31.07.2024 00:00:00 61.967 0 3.593.593 58,0 Fosstodon 4.2.10 500 Di 30.07.2024 00:00:20 61.967 +2 3.590.362 57,9 Fosstodon 4.2.10 500 Mo 29.07.2024 00:00:12 61.965 -1 3.587.302 57,9 Fosstodon 4.2.10 500 So 28.07.2024 00:00:15 61.966 +3 3.586.611 57,9 Fosstodon 4.2.10 500 Sa 27.07.2024 00:00:14 61.963 +5 3.583.830 57,8 Fosstodon 4.2.10 500 Fr 26.07.2024 00:01:07 61.958 +1 3.580.868 57,8 Fosstodon 4.2.10 500 Do 25.07.2024 00:00:10 61.957 +1 3.577.506 57,7 Fosstodon 4.2.10 500 Mi 24.07.2024 00:01:07 61.956 0 3.574.077 57,7 Fosstodon 4.2.10 500 Di 23.07.2024 00:00:03 61.956 -3 3.570.705 57,6 Fosstodon 4.2.10 500 Mo 22.07.2024 00:01:10 61.959 0 3.567.825 57,6 Fosstodon 4.2.10 500
yezzer (@yezzer) · 10/2022 · Tröts: 931 · Folger: 626
Mi 31.07.2024 08:12
Hey #3dprinting people, I haven't used my Bambu P1P for at least 6 months, maybe longer.
Have cleaned belts + lubed screws + soap washed textured PEI plate + IPA'd it.
Any idea what's causing bad adhesion on first layer? Using Bambu PLA-CF.
Filament could be damp? Would that cause this? Don't have a dryer yet (arrives later today)
Profile is known good config from ages ago - but was printing very specific things with large flat base, not this, so perhaps might have not noticed this issue..
bad first layer adhesion on a 3d print
bad first layer adhesion on a 3d print
filament profile from bambu studio
[Öffentlich] Antw.: 0 Wtrl.: 1 Fav.: 0